| | Home | Products | Software | Download | News | Search | F.A.Q. | | |||||
Latest News |
|||||
| Navigation |
|
|
 |
September 10, 2005 |  |
New: German version of the website!
The website is now also available in German. Via the language label at the top-right of the page, you can set the language.
|
August 9, 2005 | |
New measurement software, version 2.76
There is new measurement software available, version 2.76, for the following instruments:
The Auto Disk function in the oscilloscope and the transient recorder is no longer limited to 1000 measurements, but will measure until stopped by the user or when the disk is full.
Further some minor bugs have been solved and some other minor improvements have been made.
|
August 3, 2005 | |
New measurement software, version 2.75
There is new measurement software available, version 2.75a, for the following instruments:
Bugs have been solved in:
- Voltmeter
- Saving and restoring waveforms
- Handyscope HS3 and Handyscope HS4 software, regarding a missing driver file.
Further some minor bugs have been solved and some other minor improvements have been made.
|
July 29, 2005 | |
Multi Channel software update, version 0.40
Version 0.40β of the new Multi Channel software is now available for download. There is also a demo version, which can be used without connecting measuring instruments.
Some of the changes:
- Instrument bar is now on a toolbar.
- Added channel toolbars for quick acces to channel properties.
- Dragging of complete instrument from the treeview onto a graph or a sink or I/O block supported.
- Active instrument highlighted in object treeview.
|
July 12, 2005 | |
Multi Channel software update, version 0.30
Version 0.30β of the new Multi Channel software is now available for download. There is also a demo version, which can be used without connecting measuring instruments.
Some of the changes:
- Handyscope HS3 can use 256 KSamples per channel by disabling the function generator.
- Handyscope HS3 function generator can start after an external trigger.
- Handyscope HS3 function generator burst mode enabled.
- User can select signal frequency or sample frequency for the function generator.
- FFT didn't recalculate on a pre-samples / datasize change. Now it does...
- Added Multiply/Divide object for multiplying and dividing up to 32 sources.
- Added support for special firmware.
- Absolute value processing block added.
- Differentiate processing block added.
- Integrate value processing block added.
- I2C bus analyzer added.